NA-NP-IE系列实验43:交换机基本配置
本文共 5088 字，大约阅读时间需要 16 分钟。
实验43:交换机基本配置
1. 实验目的
通过本实验，读者可以掌握如下技能：
（1） 熟悉交换机的基本配置
2. 实验拓扑
拓扑图
3. 实验步骤
注：默认时交换机的以太网接口是开启的。对于交换机的以太网口可以配置其双工模式、速
率等。
用CONSOLE线连接好PC和交换机后，打开PC的开始--所有程序--附件--通讯--超级终端--
C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)
Compiled Mon 22-Jul-02 18:57 by miwang
Cisco WS-C2950T-24 (RC32300) processor (revision C0) with 21039K bytes of memory.
2950T-24 starting...
Base ethernet MAC Address: 0090.0C1D.7B74
Xmodem file system is available.
Initializing Flash...
flashfs[0]: 1 files, 0 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 64016384
flashfs[0]: Bytes used: 3058048
flashfs[0]: Bytes available: 60958336
flashfs[0]: flashfs fsck took 1 seconds.
...done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
Loading "flash:/c2950-i6q4l2-mz.121-22.EA4.bin"...
########################################################################## [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA4, RELEASE SOFTWARE(fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 18-May-05 22:31 by jharirba
Cisco WS-C2950T-24 (RC32300) processor (revision C0) with 21039K bytes of memory.
Processor board ID FHK0610Z0WC
Running Standard Image
24 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
63488K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 0090.0C1D.7B74
Motherboard assembly number: 73-5781-09
Power supply part number: 34-0965-01
Motherboard serial number: FOC061004SZ
Power supply serial number: DAB0609127D
Model revision number: C0
Motherboard revision number: A0
Model number: WS-C2950T-24
System serial number: FHK0610Z0WC
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA4, RELEASE SOFTWARE(fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 18-May-05 22:31 by jharirba
Press RETURN to get started!
Switch>en
Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#hostname sw2950
sw2950(config)#enable secret cisco 配置进入特权模式的密码
sw2950(config)#line vty 0 15
sw2950(config-line)#password cisco 设置 VTY 密码
sw2950(config-line)#login
sw2950(config-line)#no ip domain-lookup
sw2950(config)#line console 0
sw2950(config-line)#loggin synchronous 同步
sw2950(config-line)#exec-timeout 00 设置超时
sw2950(config-line)#exit
sw2950(config)#do sh ip int
sw2950(config)#do sh ip int
sw2950(config)#do sh ip inter
sw2950(config)#do sh ip interface brief 查看所有接口的情况
Interface IP-Address OK? Method Status Protocol
FastEthernet0/1 unassigned YES manual down down
FastEthernet0/2 unassigned YES manual down down
FastEthernet0/3 unassigned YES manual down down
FastEthernet0/4 unassigned YES manual down down
FastEthernet0/5 unassigned YES manual down down
FastEthernet0/6 unassigned YES manual down down
FastEthernet0/7 unassigned YES manual down down
FastEthernet0/8 unassigned YES manual down down
FastEthernet0/9 unassigned YES manual down down
FastEthernet0/10 unassigned YES manual down down
FastEthernet0/11 unassigned YES manual down down
FastEthernet0/12 unassigned YES manual down down
FastEthernet0/13 unassigned YES manual down down
FastEthernet0/14 unassigned YES manual down down
FastEthernet0/15 unassigned YES manual down down
FastEthernet0/16 unassigned YES manual down down
FastEthernet0/17 unassigned YES manual down down
FastEthernet0/18 unassigned YES manual down down
FastEthernet0/19 unassigned YES manual down down
FastEthernet0/20 unassigned YES manual down down
FastEthernet0/21 unassigned YES manual down down
FastEthernet0/22 unassigned YES manual down down
FastEthernet0/23 unassigned YES manual down down
FastEthernet0/24 unassigned YES manual down down
GigabitEthernet1/1 unassigned YES manual down down
GigabitEthernet1/2 unassigned YES manual down down
Vlan1 unassigned YES manual administratively down down
sw2950(config)#
sw2950(config)#
sw2950(config)#int f0/1
sw2950(config-if)#duplex full //duplex 用来配置接口的双工模式，full——全双工
sw2950(config-if)#speed 100 设置速度为 100M
sw2950(config-if)#exit
sw2950(config)#int vlan 1
sw2950(config-if)#ip address 172.16.1.1 255.255.255.0
交换机也允许被telnet，这时需要在交换机上配置一个IP 地址,这个地址是在VLAN 接
口上配置的。
sw2950(config-if)#no sh
%LINK-5-CHANGED: Interface Vlan1, changed state to upsw2950sw2950(config-if)#exit
sw2950(config)#ip default-gateway 172.16.1.254
// 以上在VLAN 1 接口上配置了管理地址，接在VLAN 1 上的计算机可以直接进行telnet 该
地址。为了其他网段的计算机也可以telnet 交换机，我们在交换机上配置了缺省网关。
sw2950(config)#do copy running startup 保存配置
本文转自gauyanm 51CTO博客，原文链接：http://blog.51cto.com/gauyanm/241946，如需转载请自行联系原作者
你可能感兴趣的文章
Android应用目录结构分析
查看>>
动画总结(UIView的动画)
查看>>
顶点着色器和片断着色器
查看>>
vc++实现禁用按钮
查看>>
flask with gae开发小结
查看>>
以打字形式展示placeholder的插件
查看>>
http文件导出写文件
查看>>
Globus的简单介绍
查看>>
[LeetCode] Search Insert Position 解题报告
查看>>
c# 的传递参数值传递与传递引用的区别，ref与out区别
查看>>
win7+vs2008+cuda5.x 环境配置二
查看>>
PHP5.5安装PHPRedis扩展
查看>>
c#Socket Tcp服务端编程
查看>>
java构造函数注意点
查看>>
Asp.net 中配置 CKEditor和CKFinder
查看>>
Use dynamic type in Entity Framework 4.1 SqlQuery() method
查看>>
《Python CookBook2》 第四章 Python技巧 - 若列表中某元素存在则返回之 && 在无须共享引用的条件下创建列表的列表...
查看>>
redhat网卡设置
查看>>
javascript 的作用域
查看>>
JFinal极速开发框架使用笔记(二) 两个问题，一个发现
查看>>